Home About Us Contact Register Store                 G-Riser Assembly Instructions   G-Riser Home Page News and Reviews Press Releases Step 1 Disconnect all cables from your G3 or G4, and place it in an area where you will have access to all sides. Then layout the G-Riser legs, placing them so the clips on the outer side face outward. See the picture to the right Step 2 Lift one end of your G3 or G4 by the upper handle. With your other hand insert one of the G-Riser legs onto the Mini-Tower. You will need to insert the legs at a slight inward angle and pivot the legs outward until the legs snap into place. Notice the clips resting against the G3 or G4 legs. See the pictures to the right Step 3 Repeat step 2 for installing the remaining G-Riser leg. See the picture to the right   Step 4 At this point you are done. Your G3 or G4 should look like the picture on the right.   Home | News & Reviews | Press Release | Contact Us | Contour Store